Installing A Scsi Hard Disk Drive On A Phaser 340; Figure 2-3 Connecting A Scsi Hard Disk Drive To A Phaser 340 - Tektronix Phaser 340 Service Manual

2
Installing the Printer and Drivers

Installing a SCSI hard disk drive on a Phaser 340

2-12 Phaser 340 Color Printer
Perform this procedure if the customer has a hard disk drive available for font
storage. Otherwise, continue to the next procedure, "Connecting the optional
CopyStation to the printer".
1. Make sure that the printer and the SCSI disk drive are turned off.
2. Attach the SCSI cable to the printer's SCSI port. The printer may
require the SCSI cable (part numbered 013-1465-00) to connect the
drive's standard 50-pin SCSI connector to the smaller, high-density
SCSI connector on the printer's rear panel.
3. Attach the other end of the SCSI cable to the SCSI drive.
4. Attach a terminator to the SCSI drive's second connector. (This is not
required if the disk drive is internally terminated.)

Figure 2-3 Connecting a SCSI hard disk drive to a Phaser 340

5. Turn on the disk drive first, and then the printer.
6.
Refer to the Phaser 340 Driver and Utilities Printing Reference for details
on formatting a SCSI disk, controlling Sys/Start job files, and using the
LaserWriter Utility to load fonts onto the disk drive.
Phaser 340 SCSI
PHASER 340
Ethernet®
1 2
Service Reset Second
Feeder
SCSI Disk Parallel
Service
Only
Smart Card
Disk
drive
SCSI Terminator
SCSI
9100-10