Installing A Scsi Hard Disk Drive On A Phaser 300I (Optional); Figure 2-3 Connecting A Scsi Hard Disk Drive To The Phaser 300I - Tektronix Phaser 300i Service Manual

Installing a SCSI hard disk drive on a Phaser 300i (optional)

Perform this procedure if the customer has a hard disk drive available for font
storage. Otherwise, continue to the next procedure.
1. Make sure that the printer and the SCSI disk drive are turned off.
2. Attach the SCSI cable to the printer's SCSI port.
3.
Attach the other end of the SCSI cable to the SCSI drive.
4. Attach a terminator to the SCSI drive's second connector. (This is not
required if the disk drive is internally terminated.)
1
1 2 3 4 5 6 7 8 9 PXi
* *
Reset Skip Metric 1200 Serial
Diagnostics Startjob Paper Size Baud Rate Color Correction
Run Run American Variable LocalTalk™ (RS-232)
* See User Status
Manual

Figure 2-3 Connecting a SCSI hard disk drive to the Phaser 300i

5.
Select the desired SCSI address (0 through 6) on the SCSI drive. The
printer's SCSI address is 7.
6. Turn on the disk drive first, and then turn on the printer.
7.
Refer to the Phaser 300i Drivers and Utilities Printing Reference for
details on formatting the SCSI disk, controlling Sys/Start job files, and
using the LaserWriter Utility to load fonts onto the disk drive.
Installing the Printer and Drivers
2
Not Installed
Ethernet®
Parallel SCSI Disk
3 4
SCSI
8818-33
Service Manual 2-13
2