Fru Disassembly/Assembly; Required Tools; The Printer Cabinet; Upper Rear Cover - Tektronix Phaser 560 Service Manual

8

FRU Disassembly/Assembly

The printer cabinet

Upper rear cover

Lower rear cover

Top cover

Left door (for paper feeder access)

Left side cover

8-2 Phaser 560 Color Printer

Required tools

Phillips #2 long shank
1. Remove the four screws securing the upper rear cover in place.
Note
Note that the lower rear cover clips underneath the printer frame. Lift
the printer slightly to remove the lower rear cover in the next step.
1. Remove the four screws securing the lower rear cover in place.
1.
Remove the upper rear cover first.
2. Remove the three screws securing the rear of the top cover in place.
3. The front of the top cover is held by metal tabs. Tilt the cover up from
the rear, slide it back slightly and remove.
1.
Open the left door.
2. Unhook the retaining strap from the door.
3. Unpin the door from the engine frame. Unpin the rear of the door
first. Note the spring on the front hinge. The spring ends are different, so
it must be oriented so the wide end faces the front of the printer .
1. Lower the multi-purpose feeder tray.
2. Remove the upper rear cover and top cover.
3.
Gently squeeze the plastic retaining hooks at each upper corner of the
left side cover to unhook the cover from the printer frame. Tilt
forward and remove the cover.
4. Multi-purpose feeder tray.
retaining pins inward to free it from the print engine frame.
Phillips #2
Tilt the tray up slightly and squeeze the tray's