Figure 8-17 Removing The Drum/Transfix Assembly (Right Side) - Tektronix Phaser 340 Service Manual

11. Right side. Remove the drum fan and drum gear.
12. Remove the Y-axis belt drive assembly and its belts. If necessary, refer
to the previous procedure, "Y-axis belt drive assembly" on page 8-18.
13.
Disconnect the wiring leading to I/O board 3. Remove the three
screws securing the board in place and remove the board.
14. Remove the five screws securing the right side of the drum/transfix
assembly to the print engine. Note that one screw is removed with a
hex key.
15.
Remove the exit roller gear train; it is held onto the exit roller shaft by
an E-ring.
16. Remove the E-ring and bushing at the right end of the paper
preheater's feed roller. (It's not necessary to remove the E-ring, gear
and bushing on the left end of the preheater's feed roller.)
Figure 8-17 Removing the drum/transfix assembly (right side)
Field Replaceable Unit Disassembly/Assembly
I/O board 3
Service Manual
8
Paper exit
gear train
Hex key
screw
9100-48
8-29