Nvram On The Controller - Ricoh B230 Service Manual

Contact your supervisor for details on how to enter the device number and
destination code.
SC 999 or "Fusing Unit Setting Error" can be shown until the device number
and destination code are correctly programmed.
11. Turn the main switch off and on.
12. Copy the data from the SD card to the NVRAM (
successfully copied them to the SD card.
13. Turn the main switch off. Then remove the SD card from SD card slot 3.
14. Turn the main switch on.
15. Specify the SP and UP mode settings.
16. Do the process control self-check.
17. Do ACC for the copier application program.
18. Do ACC for the printer application program.

NVRAM on the Controller

If you change the NVRAM in the controller, and the Data Overwrite Security unit is
installed, this Data Overwrite Security unit must be replaced with a new one.
1. Make sure that you have the SMC report (factory settings). This report comes
with the machine.
2. Output the SMC data (
3. Turn the main switch off. Then put a blank formatted SD card into SD card slot 3.
4. Turn the main switch on.
5. Copy the NVRAM data (
( SP5846-051) to an SD card if possible.
An error message shows if local user information cannot be stored in an SD
card because the capacity is not enough.
You cannot do this procedure if the SD card is write-protected.
6. Enter SP mode. Then print out the SMC reports (
7. Turn off the main switch. Then unplug the power cord.
8. Replace the NVRAM on the controller. Then reassemble the machine.
9. Check if the serial number shows on the operation panel. (SP5-811-002). Input
the serial number if it does not show. (Contact your supervisor about this
setting.)
10. Plug in the power cord. Then turn the main switch on.
B230/B237
SP5-990-001) if possible.
SP5-824-001) and the address book data in the HDD
3-108
SP5-825-001) if you have
SP5-990-001) if possible.
SM