Ricoh B230 Service Manual page 972

Error Codes
Code Meaning
because PPR was
transmitted/received 9
(default) times within the
same ECM frame.
2-11 Only one V.21 connection
flag was received
2-12 Modem clock irregularity
2-13 Modem initialization error
2-23 JBIG compression or
reconstruction error
2-24 JBIG ASIC error
2-25 JBIG data reconstruction
error (BIH error)
2-26 JBIG data reconstruction
error (Float marker error)
2-27 JBIG data reconstruction
error (End marker error)
2-28 JBIG data reconstruction
error (Timeout)
2-29 JBIG trailing edge maker
error
2-50 The machine resets itself
for a fatal FCU system
error
2-51 The machine resets itself
because of a fatal
communication error
2-53 Snd msg() in the manual
task is an error because
the mailbox for the
operation task is full.
4-01 Line current was cut
4-10 Communication failed
because of an ID Code
mismatch (Closed
Network) or Tel. No./CSI
B786
Suggested Cause/Action
Try adjusting the cable equalizer setting.
Replace the FCU.
Replace the FCU.
Turn off the machine, then turn it back on.
Update the modem ROM.
Replace the FCU.
Turn off the machine, then turn it back on.
Turn off the machine, then turn it back on.
JBIG data error
Check the sender's JBIG function.
Update the MBU ROM.
FCU defective
Check the destination device.
If this is frequent, update the ROM, or replace
the FCU.
If this is frequent, update the ROM, or replace
the FCU.
The user did the same operation many times,
and this gave too much load to the machine.
Check the line connector.
Check for line problems.
Replace the FCU.
Get the ID Codes the same and/or the CSIs
programmed correctly, then resend.
The machine at the other end may be
defective.
22 SM