Ricoh B230 Service Manual page 973

Code Meaning
mismatch (Protection
against Wrong
Connections)
5-10 DCR timer expired
5-20 Storage impossible
because of a lack of
memory
5-21 Memory overflow
5-23 Print data error when
printing a substitute rx or
confidential rx message
5-25 SAF file access error
6-00 G3 ECM - T1 time out
during reception of
facsimile data
6-01 G3 ECM - no V.21 signal
was received
6-02 G3 ECM - EOR was
received
6-04 G3 ECM - RTC not
detected
6-05 G3 ECM - facsimile data
frame not received within
18 s of CFR, but there was
no line fail
6-06 G3 ECM - coding/decoding
error
6-08 G3 ECM - PIP/PIN
received in reply to
PPS.NULL
6-09 G3 ECM - ERR received
SM
Suggested Cause/Action
Replace the FCU.
Temporary memory shortage.
Test the SAF memory.
Test the SAF memory.
Ask the other end to resend the message.
Replace an SD card or HDD.
Replace the FCU.
Try adjusting the rx cable equalizer.
Replace the FCU.
Check the line connection.
Check for a bad line or defective remote
terminal.
Replace the FCU.
Check the line connection.
Check for a bad line or defective remote
terminal.
Replace the FCU.
Try adjusting the rx cable equalizer
Cross reference
Rx cable equalizer - G3 Switch 07 (PSTN)
Defective FCU.
The other terminal may be defective.
The other end pressed Stop during
communication.
The other terminal may be defective.
Check for a noisy line.
Adjust the tx levels of the communicating
machines.
See code 6-05.
23
Error Codes
B786