Seal Check and Removal
You must check the box seals to make sure that they were not removed after
the items were sealed in the box at the factory before you do the installation.
1.
Check the box seals [A] on each corner of the box.
Make sure that a tape is attached to each corner.
The surfaces of the tapes must be blank. If you see "VOID" on the tapes, do not
install the components in the box.
2.
If the surfaces of the tapes do not show "VOID", remove them from the corners
of the box.
3.
You can see the "VOID" marks [B] when you remove each seal. In this condition,
they cannot be attached to the box again.
SM
1-77
B230/B237