Color Registration - Ricoh B230 Service Manual

1. Enter SP2-109.
2. Print out the test pattern (14: 1-dot trimming pattern) with SP2-109.
3. Check the erase margin A and B. Adjust them with SP2-103 if necessary.
Leading edge: 1.5 to 5.0 mm,
Side-to-side:0.5 to 4.0 mm,
Trailing edge: 0.5 to 0.6 mm

3.3.5 COLOR REGISTRATION

Line Position Adjustment
The automatic line position adjustment usually is done for a specified condition to get the
best color prints.
Do the following if color registration shifts:
Do "Auto Color Registration" as follows to do the forced line position adjustment.
1. First do SP2-111-3.
2. Then do SP2-111-1.
To check if SP 2-111-1 was successful, watch the screen during the process. A
message is displayed at the end. Also, you can check the result with SP 2-194-10
to -12.
You should also do the line position adjustment at these times:
After you transport or move the machine (you should do the forced line position
adjustment if you install the machine at the user location.) if the machine is
pre-installed at the workshop and moved to the user location,
When you open the drum positioning plate
SM 3-7 B230/B237