Auto Off Mode - Ricoh B230 Service Manual

temperatures indicated in the table at the bottom of the page. The operation panel
indicators are turned off except for the Energy Saver LED and the Power LED.
If the controller receives an image print out command from an application program (e.g. to
print incoming fax data or to print data from a PC), the temperature of each fusing lamp
rises to print the data.
Return to stand-by mode
The machine returns to stand-by mode if one of the following is done:
The Clear Mode/Energy Saver Mode key is pressed
Any key on the operation panel or touch panel screen is pressed
An original is placed in the ADF
The ADF is lifted
A sheet of paper is placed in the by-pass feed table
The return time from the panel off mode is less than 30 seconds.
Operation
Mode
Switch
Panel off On

Auto Off Mode

There are two Auto Off modes: Off Stand-by mode and Off mode. The difference between
Off Stand-by mode and Off mode is the machine's condition when it enters the Auto Off
mode.
Entering off stand-by and off modes
The machine enters the Off Stand-by mode or Off Mode when one of the following is done.
The auto off timer runs out.
The operation switch is pressed to turn the power off.
If one or more of the following conditions exists, the machine enters Off Stand-by mode. If
none of these conditions exist, the machine enters the Off Mode.
Error or SC condition
Image data is stored in the memory
During memory TX or polling RX
The handset is off hook
An original is in the ARDF
SM
Energy
Saver Fusing Temperature
LED
Heating roller: 100°C
On
Pressure roller: 130°C
6-71
System
+24V
+5V
On On
B230/B237