1.
Turn the main switch off.
2.
Insert the original SD card in SD Card Slot 3. The application program is copied
back into this card.
3.
Insert the SD card (having stored the application program) to SD Card Slot 1.
The application program is copied back from this SD card.
4.
Turn the main switch on.
5.
Start the SP mode.
6.
Select SP5-873-002 "Undo Exec."
7.
Follow the messages shown on the operation panel.
8.
Turn the main switch off.
9.
Remove the SD card from SD Card Slot 3.
This step assumes that the application programs in the SD card are used by
the machine.
10. Turn the main switch on.
11. Check that the application programs run normally.
12. Make sure that the machine can recognize the option (see 'Check All
Connections' at the end of this section).
1.20.3 POSTSCRIPT 3
Unplug the main machine power cord before you do the following
procedure.
1.
Remove the slot cover [A] from SD card slot 2 (
2.
Turn the SD-card [B] label face to the rear of the machine. Then push it slowly
into slot 2 until you hear a click.
B230/B237
x 1).
1-66
SM