3.
Plug in and turn on the main power switch.
4.
Check or set the following SP codes with the values shown below.
SP No.
SP5-836-001
SP5-836-002
5.
Check the operation.
6.
Make sure that the machine can recognize the option (see 'Check All
Connections' at the end of this section).
1.20.5 IEEE1394 (FIREWIRE)
Installation Procedure
Unplug the main machine power cord before you do the following
procedure.
You cannot install the USB host interface at the same time as the IEEE1394 unit.
1.
Remove the slot cover [A] from I/F Card Slot A (
2.
Install the FireWire board [B] (Knob-screw x 2) into I/F card slot A.
3.
Make sure that the machine can recognize the option (see 'Check All
Connections' at the end of this section).
UP Mode Settings for IEEE 1394
Enter the UP mode. Then do the procedure below to perform the initial interface settings for
IEEE 1394. These settings take effect every time the machine is powered on.
B230/B237
Title
Capture Function (0:Off 1:On)
Panel Setting
1-68
Setting
"1"
"0"
x 2).
SM