Nvram On The Controller; Eeprom On The Ecb And The Nvram On The Controller - Ricoh G092 Service Manual

NVRAM on the Controller

1. Enter SP mode and print out the SMC reports with SP5-990 if possible.
2. Turn off the main switch and unplug the power cord.
3. Replace the NVRAM on the controller and reassemble the machine.
4. Execute the RAM clear for the controller settings and counters with SP5-801-3,
-8, -11, and SP7-808-1.
5. Contact your regional representative to enter the machine's serial number and
destination code.
NOTE: The destination code can only be entered using a secured access
procedure. This is necessary to prevent unauthorized changing of the
product's destination code.
6. Enter the SP mode data (changes as) indicated on the printer's original SMC
report and the current SMC report printed in Step 1 of this procedure.

EEPROM on the ECB and the NVRAM on the Controller

1. Enter SP mode and print out the SMC reports with SP5-990 if possible.
2. Turn off the main switch and unplug the power cord.
3. Replace the EEPROM on the ECB and the NVRAM on the controller, and
reassemble the machine.
4. Execute the RAM clear with SP5-801-1 and SP7-808-1.
5. Contact your regional representative to enter the machine's serial number and
destination code.
NOTE: The destination code can only be entered using a secured access
procedure. This is necessary to prevent unauthorized changing of the
product's destination code.
6. Enter the SP mode data (changes) as indicated on the printer's original SMC
report and the current SMC report printed in Step 1 of this procedure.
SM
ELECTRICAL COMPONENTS
3-31 G081/G092