Ricoh B230 Service Manual page 783

one card to another card. This is done for the following reasons:
1. The SD card can be the only proof that the user is licensed to use the application
program.
2. You may need to check the SD card and its data to solve a problem in the future.
5. You cannot copy PostScript data to another SD card. You have to copy other
data to the same SD card that stores PostScript data.
5.7.2 MOVE EXEC
The menu "Move Exec" (SP5-873-001) lets you copy application programs from the original
SD card to another SD card.
Do not turn ON the write protect switch of the system SD card or application SD
card on the machine. If the write protect switch is ON, a download error (e.g. Error
Code 44) occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that an SD card is in SD Card Slot 1. The application program is
copied into this SD card.
3. Insert the SD card (having stored the application program) to SD Card Slot 3.
The application program is copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 "Move Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 3.
10. Turn the main switch on.
11. Check that the application programs run normally.
5.7.3 UNDO EXEC
The menu "Undo Exec" (SP5-873-002) lets you copy back application programs from an
SD card to the original SD card. You can use this program when, for example, you have
mistakenly copied some programs by using Move Exec (SP5-873-001).
Do not turn ON the write protect switch of the system SD card or application SD
card on the machine. If the write protect switch is ON, a download error (e.g. Error
Code 44) occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
SM 5-417 B230/B237