Clear Programmed Data / User Settings; All Ram Clear - Muratec F-360 Field Engineering Manual

3.6 Clear Programmed Data / User Settings

User programmed information such as autodialer entries, date, time, Transmit Terminal Identifier (TTI),
Subscriber ID, etc., are stored in the unit's Random Access Memory (RAM). A battery back up when the
power is lost holds this information.
This function does not clear the machine parameters, memory switches and unique switches. Therefore, this
setting is useful to reset the user programmed information but leave specific parameters and switches
configured for a particular telephone system, etc.
Note: If desired, the All RAM Clear setting can be used to erase all user programmed information, all
documents in memory, and reset the Memory switches and Unique switch parameters to factory
defaults. For information on the All RAM Clear setting, sees "3.7 All RAM Clear," page 3-102.
1. To clear programmed data and user settings, from standby, press MENU, *, 0, 2.
2. Press [Enter].
Note: To finish the operation without performing initialization, press [Cancel].

3.7 All RAM Clear

The All RAM Clear setting will erase all user programmed information, all documents in memory, and reset
the Memory switches and Unique switch parameters to factory defaults.
This feature may also be used to try and clear a machine malfunction or lock up. If possible, when the All
RAM Clear is used to reset a malfunction or lock up, it is advisable to print the machine settings, one-touch
and speed dial listings to help in reprogramming this information.
Note: The All RAM Clear does not clear the machine parameters, life monitor and consumable order sheet.
If you need to clear them, see "3.2.2 Clearing the Machine Parameters," page 3-2 and/or "3.16 Clear
Life Monitor," page 3-120.
1. To perform an All RAM Clear, from standby, press MENU, *, 0, 3.
2. Press [Enter].
Note: To finish the operation without performing All RAM clear, press [Cancel].
3-102