Muratec F-360 Field Engineering Manual page 249

11. Insert the PRINTER CONTROL PCB completely and then secure it using a screw.
If you're attaching the NIC PCB, secure it using a screw, too. And then attach the O.P. Shield.
12 Re-attach the SHIELD PLATE and the REAR COVER you have removed in step 2.
13 Cut out the rectangular connector space for the printer port on the OPTION COVER A (you have
removed in step 1). Then reattach it.
If you have installed both the Printer control board and NIC, attach the OPTION COVER B instead of
the OPTION COVER A.
The OPTION COVER B is included in the NIC kit's carton box.
O.P. Shield
Option cover A
Option cover B
6-24