Muratec F-360 Field Engineering Manual page 248

3. Except for the North American version, connect the CONNECTION CABLE B and CONNECT OPTION
PCBs and CONNECTION CABLE C as shown below.
Note: Take notice of the CONNECT OPTION PCBs' direction.
For MFX-1200/1250/1600, F-320
Connect to the P14B
on the Main control PCB
For F-360
Connect to the P14E
on the Sub main PCB
Connection cable C
Connection harness A
Connection harness B
Note: The North American version does not need to attach the Connect option 1 and 2 PCB.
Note: The connection cable is shorter than illustrated.
4. Remove the CABLE CAP from one end of the CONNECTION CABLE A as illustrated above.
Then plug the other end of CONNECTION CABLE A to P14A on the MAIN CONTROL PCB.
5. If the machine is F-320:
For North American version, plug the other end of the CONNECTION CABLE B to P14B on the MAIN
CONTROL PCB.
For European version, plug the other end of the CONNECTION CABLE C to the P14B on the MAIN
CONTROL PCB.
If the machine is an F-360:
For North American version, plug the other end of the CONNECTION CABLE B to P14E on the SUB
MAIN PCB.
For European version, plug the other end of the CONNECTION CABLE C to the P14E on the SUB MAIN
PCB.
Note: For European version, take notice of the connection cable's direction.
6. Pass the other end of CONNECTION CABLE A and B (and C) through the rear frame of the machine.
7. Plug the CONNECTION CABLE A to the CON 2 on the PRINTER CONTROL PCB.
8. If you also install the NIC PCB, connect it to the PRINTER CONTROL PCB.
9. Temporarily insert the PRINTER CONTROL PCB into the left slot. Be careful not to hit it against the "A"
part (see the illustration above) of the machine's frame and damage CON 2.
10. Plug the CONNECTION CABLE B (or C) to the CON1 on the PRINTER CONTROL PCB.
Connect option 2 PCB
Connection cable B
Red connector
PCB CONNECT
TO MAIN
OPT 2
Frrite core
Connect option 1 PCB
)
6-23
Red connector
Connect to the CON1
on the Printer control PCB
Connection cable C
Cable cap
Printer control PCB