High Voltage Power Supply (Hvps); Connect Printer Pcb - Muratec F-360 Field Engineering Manual

HIGH VOLTAGE POWER SUPPLY (HVPS)

1. Remove the FRONT COVER. (See page 5-8.)
2. Remove the shield plate.
3. Disconnect the connector on the HVPS and remove five HVPS mounting screws, then remove the
HVPS.

CONNECT PRINTER PCB

1. Remove the REAR COVER.
2. Remove two PCB shield mounting screws, and then remove the PCB shield.
3. Disconnect all connectors on the CONNECT PRINTER PCB.
4. Remove three printer connect PCB mounting screws and the tab, and then remove the CONNECT
PRINTER PCB.
PCB shield
High voltage power supply
Printer connect PCB
5-17
Shield plate