Muratec F-360 Field Engineering Manual page 105

Unique Switch 54 - Printer
Initial
Switch
Setting
7 0 Factory use only
6 0 Factory use only
5 0 Factory use only
4 0 Factory use only
LED print head exposure
time adjustment
3 0
(for receiving document
and copies)
1 step = 1.74 µs
2 0
Note: This setting takes
effect after turning the power
switch off/on.
1 0
0 0
Unique Switch 55 - Printer
Initial
Switch
Setting
Factory use only
7 1
Factory use only
6 0
Factory use only
5 1
Ignore the size error with
bypass tray
4 0
0: No
1: Yes
Factory use only
3 0
Disable the printing margin
2 0 0: No (204 mm print)
1: Yes (210 mm print)
Factory use only
1 0
Primary copying upon printing
the received data
0 1
0: No
1: Yes
Adjust
Initial setting is "000000" and 28.65 µsec.
If you want to change the exposure time, set this
switch within the following range.
If you set the time to be shorter, the print density will
be light.
Switch 3 2 1 0
Adjust
If this switch is set "1", the machine doesn't detect
the paper mismatch error when using the bypass
tray.
When this switch is set to "1", the machine will not
mask the sides of the printed document.
Note: This switch is available only for European
version.
Setting to "1", the copying job will interrupt the
printing job of a received document.
3-80
Usage/Comments
18.23 µs
0 0 0 1 Lightest
19.97 µs
0 0 1 0
21.70 µs
0 0 1 1
23.44 µs
0 1 0 0
0 1 0 1 25.17 µs
28.65 µs
0 1 1 1
1 0 0 0 30.38 µs
32.12 µs
1 0 0 1
33.85 µs
1 0 1 0
35.59 µs
1 0 1 1
37.33 µs
1 1 0 0
39.06 µs
1 1 0 1
40.80 µs
1 1 1 0
42.53 µs
1 1 1 1 Darkest
Usage/Comments