Muratec F-360 Field Engineering Manual page 250

14 Connect the bi-directional parallel printer cable to the printer interface port of printer control PCB.
Note: Attach the ferrite core included in the printer control kit's carton box to the printer cable as shown.
15 Snap the plug's wire clips onto the printer cable.
16 Connect the other end of the printer cable to the computer's parallel port.
17 If using the NIC, connect the printer to the network by using the network cable.
18 Attach the "Online label" and "Copy/Scan mode label". The "Online label" is in the Soft key label that is
included in the machine's carton box.
19 Install the driver software. (Please refer to the operating instructions.
EtherNet port Network cable
(10/100Base-T twist pair cable)
ONLINE label Copy/Scan mode label
ONLINE Copy/Scan
6-25