Muratec F-360 Field Engineering Manual page 74

Memory Switch 70 - Operation
Initial
Switch
Setting
7 0 Display error line
0: No
1: Yes
6 0 Total line monitor
0: No
1: Yes
5 0 Not used
4 0 Sort autodialer printout
0: Sort by autodialer location
1: Sort by location ID
3 1 Print check message if power
is lost
0: No
1: Yes
2 1 Print page if error occurs
during memory transmission
0: No
1: Yes
1 1 Print check message
0: No
1: Yes
0 0 Stop printing check message
for a memory transmission by
pressing the stop key
0: No
1: Yes
Memory Switch 71 - Operation
Initial
Switch
Setting
7 0 Not used
6 0 Not used
5 1 Print TCR with the original
page
4 0 Factory use only
3 1 Print TCR with the original
page
0: No
1: Yes
2 0 Factory use only
1 0 Factory use only
0 0 Display modem speed
0: No
1: Yes
Memory switch 71 ... Print TCR with the original page
Switch 3
Switch 5
When Memory transmission was OK, ...
When Memory transmission was NG, ...
When all broadcast transmissions were OK, ...
When some broadcast transmissions were NG, ...
Adjust
The number of error lines contained in the received
data will be shown in the LCD.
Allows fax communication to be heard through the
monitor speaker.
Specifies how entries on autodialer printouts are
sorted.
In the event of two power losses in a 40-hour
period, documents will be lost. When power is
restored, a check message will print.
For easy identification, the first page of a document
stored for memory transmission will print along with
a check message if an error occurs during memory
transmission.
To notify the user of an error, a check message can
be printed if a communication error occurs.
Determines if pressing the stop key stops printing
the check message for a memory transmission.
Adjust
See table below
For easy identification, the first page of a document
stored for memory transmission will print along a
TCR.
The transmit/receive speed is displayed in the LCD.
No
No
No
No
3-49
Usage/Comments
Usage/Comments
0 1
0 1 0
No Yes Yes
Yes No Yes
No Yes Yes
Yes No Yes
1