Drive Gear Assembly; Tos - Muratec F-360 Field Engineering Manual

DRIVE GEAR ASSEMBLY

1. Perform the procedure of step 1 through 3 in "RX MOTOR," page 5-34.
2. Remove the SOLENOID. (See page 5-34.)
3. Remove the four DRIVE GEAR Assembly mounting screws, then remove the DRIVE GEAR Assembly.
Drive gear assembly

TOS

1. Open the upper cover and printer cover.
2. Remove the Toner Cartridge and Drum Cartridge.
3. Disconnect the connector of TOS.
4. Remove the two TOS mounting screws, then remove the TOS.
TOS
5-35