04/SHOCK ABSORBER, SWINGARM
Front shock absorber - filling the damper with nitrogen
8.19
–
Remove the special tool.
–
Remove adapter
Info
Hold the damper so that the filling port is at the highest location.
–
Remove the adapter.
–
Mount and tighten screw
Guideline
Screw, filling port
201155-10
–
Screw in screw
Info
The piston rod is fully extended.
201156-10
–
Fix the special tool in the vise.
Nitrogen filling tool (T170S1) (
–
Connect the special tool to the pressure regulator of the filling cylinder.
Filling gas - nitrogen
–
Adjust the pressure regulator.
Guideline
Gas pressure
201157-10
–
Position the damper in the special tool.
The hexagonal part of turning handle
tion of the filling port screw.
–
Open spigot
–
Fill the damper for at least 15 seconds.
Guideline
Gas pressure
Info
Watch the pressure regulator dial.
Ensure that the damper is filled to the specified pressure.
–
Screw the filling port shut with turning handle
–
Close the spigot and remove the damper from the special tool.
–
Tighten the filling port screw.
Guideline
Screw, filling port for reservoir
from connector
of the vacuum pump.
.
by approx. 2 turns but do not tighten.
p. 239)
.
M10x1
14 Nm
(10.3 lbf ft)
10 bar (145 psi)
engages in the female hexagonal sec-
10 bar (145 psi)
.
M5
3 Nm (2.2 lbf ft)
37