Table of Contents
Advertisement
32/CLUTCH
Checking fluid level of hydraulic clutch
22.1
Info
The fluid level rises with increasing wear of the clutch lining disc.
Do not use brake fluid.
Changing the hydraulic clutch fluid
22.2
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top level of container
»
If the coolant level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
301814-10
Hydraulic fluid (15) (
–
Position the cover with the membrane. Mount and tighten screws.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
302061-10
–
Fill bleeding syringe
Bleed syringe (50329050000) (
Hydraulic oil (15) (
–
Remove the bleeder screw on the clutch slave cylinder and mount the bleeding
syringe.
302062-10
–
Inject the liquid into the system until it escapes from hole
cylinder without bubbles.
–
To prevent overflow, interrupt this process to drain fluid from the master cylinder
reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
302063-10
–
Position the cover with the membrane. Mount and tighten the screws.
–
Check that the clutch is functioning properly.
.
with membrane
.
4 mm (0.16 in)
p. 224)
.
with membrane
.
with the appropriate hydraulic fluid.
p. 227)
p. 224)
4 mm (0.16 in)
178
of the clutch master
Advertisement
Table of Contents
