13/BRAKE SYSTEM
Checking the front brake linings
16.7
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
–
Change worn brake linings immediately.
Removing front brake linings
16.8
Warning
Danger of accident Brake system failure.
–
Maintenance work and repairs must be carried out professionally.
Info
The operations are the same on the left and right.
–
Pull off dust cap
equipment).
–
Remove the bleeder screw and suck out the old brake fluid.
Info
During suction, ensure that the brake fluid reservoir is always sufficiently
filled with fresh brake fluid.
–
Tighten the bleeder screw. Remove the suction device and attach the dust cap.
302059-10
–
Add brake fluid to level
Guideline
Measurement of
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
302055-10
–
Install the wheel/wheels. (
–
Remove the wheel/wheels. (
–
Check the brake linings of both front brake calipers for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the front brake linings. (
–
Check the brake linings for damage and cracking.
»
If damage or cracking is visible:
–
Change the front brake linings. (
–
Install the wheel/wheels. (
100074-10
–
Remove the wheel/wheels. (
–
Pull the hand brake lever and release it again.
Locking pawl moves into its basic position, parking brake is deactivated.
and connect a commercially available suction device (workshop
.
5 mm (0.2 in)
p. 223)
p. 73)
p. 72)
≥ 1 mm (≥ 0.04 in)
p. 92)
p. 92)
p. 73)
p. 72)
91
.