Table of Contents
Advertisement
13/BRAKE SYSTEM
Mounting rear brake linings
16.18
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
–
Press the brake caliper by hand on to the brake disc in order to press back the
brake piston.
301830-10
–
Loosen the screw
Unscrew the screw by approx. 10 turns and use the screw to press the bearing bolt
out of the brake caliper. Remove screw.
100064-10
Note
Danger of damage Kinking of brake line.
–
Position and handle the brake line without straining it. The brake line must be
replaced if it is kinked.
–
Swing the brake caliper up, unhook it from the brake caliper support
down.
–
Remove the brake linings
–
100066-10
Clean brake caliper and brake caliper support.
–
Check the brake discs. (
–
Check that the sliding plate
insert the brake linings.
Info
Make sure that the decoupling plate
brake lining.
300265-10
while holding the hexagonal head
.
p. 74)
is seated correctly in the brake caliper support and
of the bearing bolt.
and set it
is mounted on the piston side of the
97
Advertisement
Table of Contents
