61/ATV FRONT END
Installing the A-arms
27.9
Info
The operations are the same on the left and right sides.
–
Remove screws
Info
When removing screws
301506-10
–
Remove screw
–
Remove screws
301507-10
–
Position lower A-arm
Guideline
Screw, A-arm bottom
–
Position the shock absorber in the lower A-arm. Mount and tighten screw
Guideline
Screw, front shock absorber
301507-11
–
Insert tool
Camber gauge (83019014000) (
–
Check the camber on both heim joints.
»
If the marking
–
Remove the nuts on the heim joint.
–
Turn tool
with the top edge of the A-arm.
–
Remove tool
300277-10
–
Position upper A-arm
Guideline
Screw, A-arm top
Info
The fork offset is set using the bushings
301506-11
and take off upper A-arm
, make sure that bushings
and the shock absorber out of the guide.
and take off lower A-arm
. Mount and tighten screws
in the heim joint and clip onto the A-arm.
p. 235)
is not flush with the top edge of the A-arm:
with the heim joint in steps of 180° until the marking is in line
.
with bushings
. Mount and tighten screws
.
remain in place.
.
.
M10x70
45 Nm
(33.2 lbf ft)
M10
45 Nm
(33.2 lbf ft)
.
M10x52
45 Nm
(33.2 lbf ft)
.
199
.