30/DISASSEMBLING THE ENGINE
Removing the rotor and starter idler gear
18.20
Removing the ignition pulse generator
18.21
–
Take off the timing chain and balancer gear with the needle bearings.
Info
Identify the direction of travel.
301631-10
–
Remove screw
301632-10
–
Insert special tool
Protection cover (75029090000) (
–
Attach special tool
rotor by screwing in the screw.
Extractor (58012009000) (
Info
Ensure that the spring washer remains in place.
301633-10
–
Remove starter idler gear
301634-10
–
Remove screws
–
Take off the retaining bracket.
–
Pull the cable support sleeve from the engine case.
–
Remove screws
–
Take off the ignition pulse generator with the holder.
301635-10
.
into the crankshaft.
p. 230)
to the rotor. Counteracting with the special tool, pull off the
p. 228)
.
.
.
110