11/WIRING HARNESS, BATTERY
Checking the starter relay
15.11
–
Remove the rear fender. (
–
Disconnect the negative (minus) cable of the battery.
–
Remove the starter relay from holder
–
Disconnect connector
–
Disconnect cables
600406-10
–
Connect the starter relay to a 12 V power supply as shown in the figure. Use a mul-
timeter to check the route between the terminals.
Info
When the starter relay is switched, a clicking sound can also be heard.
Resistance with the starter relay pulled
»
When the display does not equal the setpoint:
–
Change the starter relay.
700089-01
p. 70)
next to the battery.
from the starter relay.
and
from the starter relay.
0 Ω
87