02/HANDLEBAR, INSTRUMENTS
Hot start lever
6.1
Adjusting handlebar position
6.2
Hot start lever
If you pull the hot start lever to the handlebar when starting the engine, an opening is
exposed in the carburetor through which the engine can draw additional air. This gives
a leaner fuel-air mixture, which is needed for a hot start.
Possible states
Hot start function is activated – The hot start lever has been pulled all the way
•
out.
Hot start function is deactivated – The hot start lever has been pushed all the way
•
in.
301775-10
–
Remove the handlebar cushion.
Info
Protect the vehicle and its attachments from damage by covering them.
Do not bend the cables and lines.
301846-10
–
Remove the four screws
forward and set it down.
–
Remove the nuts
–
Remove screws
–
Remove screws
–
Place the handlebar bridge
Mount and tighten screw
Guideline
Screw, steering bridge
–
Mount and tighten screw
Guideline
Screw, steering column, top
–
Mount and tighten screws
Guideline
Screw, steering bridge
100099-10
–
Mount the handlebar support
new self-locking nuts
Guideline
Nut, handlebar support
–
Position the handlebar and fix it with the handlebar clamps
screws
.
Guideline
Screw, handlebar clamp
Info
Make sure cables and wiring are positioned correctly.
–
Mount the handlebar cushion.
is fitted on the left side of the handlebar.
. Remove the handlebar clamps
and remove the handlebar support
and
.
. Remove the handlebar bridge
onto the steering column in the desired position.
.
.
.
in the desired position using the screws. Mount
and tighten.
, swing the handlebar
with the screws.
.
M8
20 Nm
(14.8 lbf ft)
M20x1.5
25 Nm
(18.4 lbf ft)
M8
20 Nm
(14.8 lbf ft)
M10
45 Nm
(33.2 lbf ft)
. Mount and tighten
M8
20 Nm
(14.8 lbf ft)
13