Handlebar Position - KTM 525 XC ATV 2008 Owner's Manual

MAINTENANCE ON CHASSIS AND ENGINE
2 2
0 0 1
1
3 0 0 3
0 0
2 0 0 2
3 0 0 3
0 0 1
1

Handlebar position

Setting a narrow toe width:
Mount the wheel hub
Mount the conical ring
Mount the spacing sleeve
Mount the washer and the new self-locking nut.
100103-10
Setting a wide toe width:
Mount the spacing sleeve
Mount the conical ring
Mount the wheel hub
Mount the washer and the new self-locking nut.
100104-10
Remove the vehicle from the work stand. (
Tighten nuts
Specification
Nut, rear wheel hub
Shift gear to neutral.
100102-10
The handlebar position can be adjusted 4-fold by turning the handlebar support
the handlebar support
The holes on the handlebar support are placed at a distance of
Distance between holes
The holes on the handlebar bridge are placed at a distance of
Distance between holes
100098-10
.
with the cone facing outward.
with the cone facing inward.
with the cone facing inward.
with the cone facing outward.
.
on both sides.
M18x1,5
.
3.5 mm (0.138 in)
7.5 mm (0.295 in)
P. 31)
130 Nm
(95.9 lbf ft)
from the center.
from the center.
42
and