Feeder System - Canon NP-1010 Service Manual

C. Main Motor Unit
1. Removing the Main Motor
. Do not expose the drum cartridge to
'..'"'I
.
Do not leave finger prints or scratches
on the drum.
L
I)
2)
3)
Remove the drum cartridge and developing
assembly.
Remove the upper rear cover, upper front
cover, upper left cover, lower front cover,
and lower rear cover in the order named.
Remove the screw from the hinge (front,
rear), and insert a hinge stopper into each.
@
Screw
@ Hinge stopper
Figure 4-l 3
III.
A.
1.
1)
2)
FEEDER SYSTEM
Pick-Up Roller Unit
Removing the Manual Feed Pick-up
Roller
Remove the upper rear cover, upper front
cover, upper left cover, lower front cover,
and lower rear cover in the order named.
Open the top unit at a right angle, and re-
move the electrical unit (DC power supply,
power supply/AC driver, and high-voltage
transformer); see Figures 4-54 and 4-55.
Hold 'the top unit when removing the
3) Remove the two screws, and remove the
manual feed lower guide.
4) Open the top unit at a right angle, and dis-
connect J31 (2P) connected to the power
supply/AC PC5 and J35 connected to the
main motor clock sensor.
5) Remove the three screws, and pull out the
main motor gently.
@
Screws @I Manual feed lower guide
Figure 4-l 5
, '-.-,
4) Remove the four screws, and remove the
pick-up lower guide and manual feed pick-
up roller.
@
Screws
@ Main motor
Figure 4-14
4-6 COPYNI~T OIQEN CANON INC CANON HP-IO10 AN.0 DEC. IQ88 PAINTEN IN JAPAN QMPMME AU JAPON)
,..-".
@
Screws
@ Manual feed
'
@ Pick-up lower guide pick-up roller
Figure 4-l 6