Table of Contents
Advertisement
From the output, skew needs to be adjusted and image is as shown below,
Media
Expected
Image
Using the scale on the bracket, change
the bracket position gradually, and
check the results.
Troubleshooting
1. Remove the screw from the center hole
2. Push the bracket in the arrow direction to change the
bracket position . Pushing the idle roller connected to the
bracket may be easier to adjust the location of the bracket.
3. Fix the bracket at the new position by screw fastening
at the slit hole.
4-217
Screw in the
right side of
the slit hole
Advertisement
Table of Contents
Troubleshooting
