Table of Contents
Advertisement
● Code : 08-000
08-001
● Symptom :
The lead edge of the document failed to actuate the scan sensor within the correct time after actuating the r
egistration sensor.
● Possible Cause:
1. Scan roller or Idle roller is defective.
2. Scan sensor or actuator is defective.
3. Document paper path is contaminated.
● Troubleshooting method :
1.Check if the Scan roller and the Idle roller are operated properly.
2. Check if the scan sensor is operated. (chapter 2. : 2.3.3.7 Sensor No,50)
3. Check if the E/CLUTCH for the scan roller is operated properly.
Troubleshooting
● Error message : Original paper jam in front of scanner
Original paper does not feed in scanner
Idle Roller
Scan Roller
E/Clutch for the scan roller
E/Clutch for the P/up roller
4-128
Advertisement
Table of Contents
Troubleshooting
