Table of Contents
Advertisement
● Code : D-2
● Troubleshooting method :
[step2] There is a contaminant in the Dr. Gap.
(1) Check if there is a contaminant between Mag. Roller and Doctor Blade. Remove it with OHP film.
(2) If the problem persists, replace the imaging unit.
[step3] T1 Roller is not installed properly.
(1) Take out the ITB and check if the left/right springs of the T1 roller is installed properly. If it is defective,
reassemble it.
(2) If the problem persists, replace the ITB.
(3) If the problem persists, replace the imaging unit.
(4) Check if there is the contaminant on contact surface between imaging unit and ITB.
[step4] T2 transfer is defective.
(1) Check if the side cover is closed correctly.
Troubleshooting
● Vertical Irregular Image Density 2/3
4-181
Advertisement
Table of Contents
Troubleshooting
