Table of Contents
Advertisement
● Code : 08-004
● Symptom : The bottom edge of the document failed to pass the scan sensor after the lead edge of the
document has reached to the duplex sensor and scan sensor.
● Possible Cause:
1. Scan sensor or actuator is defective.
2. There is the contamination on paper path or a defective assembly.
● Troubleshooting method :
1. Check if the scan sensor (service Manual 2.3.3.7 Sensor 50) is operated properly.
2. Check if there is the contamination on paper path or a defective assembly.
● Code : 08-006
● Symptom :
The document is detected by sensors (Regi, Scan, Gate, Duplex, Reverse Stack) after initialization.
● Possible Cause:
1. Jam sensors and actuators are defective.
2. There is the jammed document in the DADF.
● Troubleshooting method :
1. Check if Jam sensors (service Manual 2.3.3.7 Sensor 50,51,52,53,55) are operated properly.
2. Remove the jammed paper in the DADF.
● Code : 08-008
● Symptom : DADF door is opened.
● Possible Cause: : The cover open sensor is defective.
● Troubleshooting method :
Check if the cover open sensor( service Manual 2.3.3.7 Sensor 49) is operated properly.
Troubleshooting
● Error message : Original paper jam in front of scanner duplex path
● Error message : Original paper jam inside of scanner
● Error message : Top door of scanner is open
4-132
Advertisement
Table of Contents
Troubleshooting
