Table of Contents
Advertisement
● Code : 03-008
● Symptom : Motor Signal is abnormal.
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. BLDC DEVE Motor is defective.
3. Engine Board is defective.
● Troubleshooting method :
1. Check the following.
-. Check if the Engine Board Harness is defective.
-. Check if the harness is connected to the 'BLDC DEVE' Connector on Engine Board properly.
-. Check if the harness is connected to the BLDC DEVE Motor properly.
2. If the connection is no problem, enter the EDC mode and execute the BLDC DEVE Motor test.
If the BLDC DEVE motor does not operate, replace it.
[ How to replace the BLDC motor ]
① Remove the SMPS shield.
② Remove 4 screws. Replace the BLDC Motor Ass'y.
1
Power (SMPS,FDB)
3. If the problem persists after replacing the BLDC DEVE Motor, replace the Engine Board.
Troubleshooting
● Error message : Motor does not operate: #03-008. Please turn off then on.
'BLDC DEVE'
(CN28, 14pin)
Shield
2
4-96
BLDC DEVE
Motor
Advertisement
Table of Contents
Troubleshooting
