Table of Contents
Advertisement
● Code : 01-005
● Symptom :
At printing, the paper from the tray1 has not reached to a feed sensor within a programmed period of time
after pick up.
● Possible Cause:
1. Pickup Clutch does not work.
2. Pickup roller rubber is worn out.
3. Feed Sensor is defective.
● Troubleshooting method :
Troubleshooting
● Error message : Paper jam in tray 1
1. Check the following.
-. Check if the Tray1 Pick-Up Clutch is assembled properly.
-. Check if the harness of the Tray1 Pick-Up Clutch is connected
properly.
-. Enter the EDC mode. Execute the Tray1 Pick-Up Clutch test.
(EDC Mode
101-010
Start
Test Routines
Copier Engine/DADF Test Routine
Operation Check (from sound)
2. Check if the Harness is defective.
Check if the connector is connected properly.
4-77
Stop)
To be continued on next page...
Advertisement
Table of Contents
Troubleshooting
