Table of Contents
Advertisement
● Code : 03-010
● Symptom : The motor to engage/ disengage the transfer belt does not operate.
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. T1 Engage DC Motor is defective.
3. Engine Board is defective.
● Troubleshooting method :
1. Check the following.
-. Check if the Engine Board Harness is defective.
-. Check if the harness is connected to the 'BLDC OPC' Connector on Engine Board properly.
-. Check if the harness is connected to the 'T1 Engage sensor' connector properly.
'BLDC OPC'
(CN24, 12pin)
'T1 Engage sensor'
(CN35, 3pin)
2. If the connection is no problem, enter the EDC mode and execute the T1 Engage Motor test.
If the T1 Engage motor does not operate, replace it.
[ How to replace the DC motor ]
① Remove the SMPS board shield.
② Remove 2 screws and unplug the connector. Replace the T1 engage DC motor.
T1 Engage DC
3. If the problem persists after replacing the T1 Engage DC Motor, replace the Engine Board.
Troubleshooting
● Error message : Motor does not operate: #03-010. Please turn off then on.
Motor
4-98
Advertisement
Table of Contents
Troubleshooting
