Table of Contents
Advertisement
● Code : 03-014
● Symptom : Waste toner motor does not operate.
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. Waste DC Motor is defective.
3. Engine Board is defective.
● Troubleshooting method :
1. Check the following.
-. Check if the Engine Board Harness is defective.
-. Check if the harness is connected to the 'Waste Motor & LSU Clean' Connector on Engine Board properly.
2. Check the following.
-. If the connection is no problem, enter the EDC mode and execute the Waste DC Motor test.
If the Motor is not operate, replace it.
1
Remove the Front OPC.
3
3. If the problem persists after replacing the Waste DC Motor, replace the Engine Board.
Troubleshooting
● Error message : Motor does not operate: #03-014. Please turn off then on.
'Waste mot & LSU Clean'
(CN39, 10pin)
Replace the Waste
DC Motor.
2
Remove the Front Cover.
4-101
Advertisement
Table of Contents
Troubleshooting
