Table of Contents
Advertisement
● Code : 01-014
01-016
● Symptom :
1. At Warm-up, Duplex Ready sensor has detected the paper.
2. At Printing, Duplex sensor is not off within a programmed period of time after paper moves into duplex
path.
● Possible Cause:
1. Check the Duplex Ready Sensor Harness and Connector.
2. Check if the UI message is changed by the Duplex Ready Sensor operation.
3. Check the duplex ready sensor.
● Troubleshooting method :
2. Check the following.
-. Check if the Duplex Ready Sensor is assembled properly.
-. Check if the Duplex Ready Sensor Harness is connected properly.
-. Enter the EDC mode. Execute the Duplex Ready Sensor test.
(EDC Mode
Test Routines
Operation check
Stop)
Troubleshooting
● Error message : Paper jam at the bottom of duplex path
Paper jam inside of duplex path
Copier Engine/DADF Test Routine
1. Check if the Harness is defective.
Check if the connector is connected properly.
102-390
4-86
Start
Advertisement
Table of Contents
Troubleshooting
