Table of Contents
Advertisement
Step 4. Adjusting Skew
From the output, skew needs to be adjusted and image is as shown below,
Media
Using the scale on the bracket, change
the bracket position gradually, and
check the results.
Troubleshooting
1. Remove the screw from the center hole.
2. Push the bracket in the arrow direction to change the
bracket position. Pushing the idle roller connected to
the bracket may be easier to adjust the location of the
bracket.
Expected
Image
3. Fix the bracket at the new position by screw
fastening at the slit hole.
4-216
Slit Hole
Screw in the
left side of the
slit hole
Advertisement
Table of Contents
Troubleshooting
