● Code :07-010
● Symptom : Rear Jogger does not work.
● Possible Cause: Rear Jogger Home Sensor defect, Rear Jogger Motor defect, Finisher main board
defect
● Troubleshooting method :
1. Check if the Finisher cable is connected to the
machine.
2. Open the finisher bottom cover and check the
LED on the finisher main board.
At that time, all finisher doors must be closed.
Check if the red, yellow, green LED are on.
3. If the yellow LED is not on, check the
connection of the switch in the Finisher Front Door.
Troubleshooting
● Error message : Finisher error: #07-010. Please turn off then on
4. Check if the finisher rear jogger home sensor
harness is connected properly.
5. Check if the finisher rear jogger motor harness is
connected properly.
6. Check if the rear jogger shaft is contaminated.
7. If the problem persists, replace the finisher main
board.
4-122