Samsung CLX-8540ND Service Manual page 257

Digital color laser mfp
Hide thumbs Also See for CLX-8540ND:
Table of Contents

Advertisement

● Code : 03-007
● Symptom : Motor Signal is abnormal.
● Possible Cause:
1. Harness is defective, Connector is not connected properly.
2. BLDC OPC Motor is defective.
3. Engine Board is defective.
● Troubleshooting method :
1. Check the following.
-. Check if the Engine Board Harness is defective.
-. Check if the harness is connected to the 'BLDC OPC' Connector on Engine Board properly.
-. Check if the harness is connected to the BLDC OPC Motor properly.
2. If the connection is no problem, enter the EDC mode and execute the BLDC OPC Motor test.
If the BLDC OPC motor does not operate, replace it.
[ How to replace the BLDC motor ]
① Remove the SMPS shield.
② Remove 4 screws. Replace the BLDC Motor Ass'y.
1
Power (SMPS,FDB)
3. If the problem persists after replacing the BLDC OPC Motor, replace the Engine Board.
Troubleshooting
● Error message : Motor does not operate: #03-007. Please turn off then on.
'BLDC OPC'
(CN24, 12pin)
Shield
2
4-95
BLDC OPC
Motor

Advertisement

Table of Contents
loading

Table of Contents