Table of Contents
Advertisement
● Code : J-2
● Symptom :
-. Horizontal Periodic Jitter (2~4mm pitch) for YMC Color
● Possible Cause:
1. MagRoll Auger Gear Jitter (2mm)
2. Waste toner Auger Jitter (4mm)
3. Drive unit in set is defective.
● Troubleshooting method :
[case1] MagRoll Auger Gear Jitter (2mm)
Check the Mag roller auger gear is defective. If it is defective, replace the imaging unit.
Mag.Roller Auger Gear
[case2] Waste toner Auger Jitter (4mm)
Check the waste toner auger gear is defective. If it is defective, replace the imaging unit.
Waste toner Auger Gear
[case3] Set driving unit defect
If the auger is OK, check the driving unit in set.
If necessary, replace the drive unit.
Troubleshooting
● Periodic Jitter
4-195
Advertisement
Table of Contents
Troubleshooting
