Samsung CLX-8540ND Service Manual page 243

● Code : 01-007
01-012
01-019
● Symptom :
At printing, the paper from the tray3 has not reached to the feed sensor within a regular time after pick up.
● Possible Cause:
1. Pickup Clutch does not work.
2. Pickup roller rubber is worn out.
3. Feed Sensor is defective.
● Troubleshooting method :
Troubleshooting
● Error message : Paper jam in tray 3
1. Check the following.
-. Check if the Tray3 Motor and Pick-Up Clutch are
assembled properly.
-. Check if the Tray3 Motor harness and Pick-Up Clutch
harness are connected properly.
-. Enter the EDC mode. Execute the Tray3 Pick-Up Clutch
test.
(EDC Mode Test Routines
Test Routine 101-030
Stop)
2. Check if the Harness is defective.
Check if the connector is connected properly.
4-81
Copier Engine/DADF
Start Operation Check
To be continued on next page...