Table of Contents
Advertisement
● Code : 01-004
● Symptom :
At printing, the paper from the MP tray has not reached to the feed sensor within a programmed period of
time after pick up.
● Possible Cause:
1. Pickup Clutch does not work.
2. Pickup roller rubber is worn out.
3. Feed Sensor is defective.
● Troubleshooting method :
Troubleshooting
● Error message : Paper jam in MP tray
1. Enter the EDC mode, and execute the pick up clutch test
(EDC mode : 101-0000)
If there is any problem, check the following.
-. Check if the MP Pick-Up Clutch is assembled properly.
-. Check if the harness of the MP Pick-Up Clutch is connected
properly.
2. Check if the Harness is defective.
Check if the connector is connected properly.
4-75
To be continued on next page...
Advertisement
Table of Contents
Troubleshooting
