Fuel Pump Relay; Fuel Tank - Honda Transalp XL700V Manual

Install the fuel pump mounting nuts.
Tighten the fuel pump mounting nuts in the speci-
fied sequence as shown.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the fuel tank (page 5-61).
• If the fuel pump is replaced, check the fuel meter
indication at the empty (page 20-17).
If fuel meter indicate the full position, the fuel
pump installation does not correctly.

FUEL PUMP RELAY

INSPECTION
Remove the seat (page 2-4).
Turn the ignition switch OFF.
Open the fuse box and remove the fuel pump relay.
Connect the ohmmeter to the fuel pump relay con-
nector terminals.
Connection: A – B
Connect the 12 V battery to the following fuel pump
relay connector terminals.
Connection: C – D
There should be continuity only when the 12 V bat-
tery is connected.
If there is no continuity when the 12 V battery is
connected, replace the fuel pump relay.

FUEL TANK

REMOVAL/INSTALLATION
Remove the front side cowl (page 2-9).
Remove the nut, bolt and washer.
Release the wire from fuel tank.
FUEL SYSTEM (PGM-FI)
NUTS
2
5
3
FUEL PUMP RELAY
FUEL PUMP RELAY
A
B
NUT/BOLT/WASHER
4
6
1
FUEL PUMP
ASSEMBLY
C
D
WIRE
5-61