Install and tighten the front screw first, then tighten
the rear screw to the specified torque.
TORQUE: 4.2 N·m (0.4 kgf·m, 3.1 lbf·ft)
Install the right handlebar switch housing, aligning
the locating pin with the hole in the handlebar.
Install and tighten the front long screw first, then
tighten the rear short screw to the specified torque.
TORQUE: 0.9 N·m (0.1 kgf·m, 0.7 lbf·ft)
Install the master cylinder, holder and bolts.
Install the holder
Align the edge of the master cylinder with the
with its "UP" mark
punch mark on the handlebar and tighten the upper
facing up.
bolt first, then tighten the lower bolt.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the front brake light switch connectors.
FRONT WHEEL/SUSPENSION/STEERING
SWITCH HOUSING
SCREWS
MASTER CYLINDER
CONNECTORS
"UP" MARK
SCREWS
Align
SWITCH HOUSING
Align
HOLDER
BOLTS
13-13