Water Pump - Honda Transalp XL700V Manual

COOLING SYSTEM
Connect the ohmmeter to the fan control relay con-
nector terminals.
Connection: A – B
Connect the 12 V battery to the following fuel pump
relay connector terminals.
Connection: C – D
There should be continuity only when the 12 V bat-
tery is connected.
If there is no continuity when the 12 V battery is
connected, replace the fan control relay.

WATER PUMP

MECHANICAL SEAL INSPECTION
Remove the under cowl (page 2-13).
Check for signs of seal leakage.
A small amount of "weeping" from the bleed hole is
normal.
Install the under cowl (page 2-13).
REMOVAL
Drain the coolant from by removing the water pump
drain bolt (page 6-7).
Remove the drive sprocket cover (page 7-4).
Loosen the band screw and disconnect the water
hoses.
Remove the bolts, sealing washer and water pump
cover.
6-14
FAN CONTROL RELAY
A
B
WATER PUMP
WATER HOSES
WATER PUMP COVER
BOLT/SEALING WASHER
C
D
BLEED HOLE
BOLTS